Broadcast Tower

Broadcast Tower
SURVEY & Reanalysis TVRI JOGJA 100m

TelecommunicationTower

TelecommunicationTower
Desidn & Fabrication DRAWING SST-27.75m

Tower Roof Top

Tower Roof Top
Design & Fabrication DRAWING SST-12.5m

Senin, 13 Juli 2009

Basic Design and Construction aspects of Transmission Lines




1 INTRODUCTION 1.1 What is Transmission line?

This question can simply not be answered by a few words. Each chapter in this lecture notes probably will use to give a proper answer of it.

A transmission line is a device for the transfer of electric energy. It can transfer the energy over long or short distances, and at different voltages. Transfer of electrical energy over very long distances calls for a trunk line with high voltages. The transmission lines of very high voltages, such as; 70 kV, 150 kV, 220 kV, 400 kV, are part of a national grid (GRT in Belgium). To make it easier to understand it can be said that the transmission lines with the higher voltages are the highways in the energy transfer system. In between these highways and the small “paths”, which might call distribution network to drop the voltage line from higher level to lower level, there will be a lot of transmission lines with different voltages.

In the planning and design of transmission line, a number of requirements have to be met. From the electrical point of view, the most important requirement is insulation and safe clearances to earthed parts. These, together with the cross-section of conductors, the spacing between conductors, and the relative location of ground wires with respect to the conductors, influence the design of pylons and foundations.

"lanjutan postingan"

10 comments:

  1. Mas Jemi, apakah ada tabel untuk tower transmission line, untuk menentukan jarak antar tower? dapatnya dari mana ya?
    Thank you

    BalasHapus
  2. Jadi begini, menurut pengalaman saya kalau anda mendapatkan project Tower transmissi dari PLN, akan lebih valid dan menyakinkan jika anda (bisa) mendapatkan/minta TPG "Technical Particular & Guarante" dari PLN. PPLN sdh mempunyai standarisasi sendiri mengenai design tower mereka, kecuali structure khusus (special tower)
    Tetapi jika dari project tsb dari luar Indonesia, anda harus menetukan sendiri Length/span dari besaran tegangan yg direncanakan (kV). Thanks.

    BalasHapus
  3. Mas pernah pakai PLS-TOWER gak?

    BalasHapus
  4. mas, apa kabar??? untuk beban BTS DI ATAP, bebannya dalam satuan beban merata atau beban terpusat yah???

    BalasHapus
  5. untuk bentang kurang lebih 1 km melewati laut harusnya menggunakan tower brp kv..dan speknya seperti apa

    BalasHapus
  6. untuk bentang kurang lebih 1 km melewati laut harusnya menggunakan tower brp kv..dan speknya seperti apa

    BalasHapus
  7. I loved as much as you will receive carried out right here.
    The sketch is attractive, your authored subject matter stylish.

    nonetheless, you command get got an edginess over that you wish be delivering the following.

    unwell unquestionably come more formerly again as exactly
    the same nearly very often inside case you shield this
    increase.

    Also visit my webpage - sell house without agent

    BalasHapus
  8. Hi there, always i used to check web site posts here in the early
    hours in the dawn, because i enjoy to gain knowledge of more and more.


    Here is my site ... jobs in cincinnati oh

    BalasHapus

Comment here

My Pictures